Houses don't come with instruction manuals. Little emergencies inevitably crop up, and new homeowners aren't always equipped to deal with them.
To help, we've put together a list of some tasks every homeowner should know how to do. It certainly doesn't represent everything you'll need to know about your house, but it's a good start.
Put together a tool kit
At the very least, you should own a curved-claw hammer, an adjustable wrench, needle-nose and standard pliers, slotted and Phillips screwdrivers in a couple of sizes and a pair of safety glasses.
An electric drill and a set of twist bits are also invaluable. Cordless drills are convenient but may not have enough torque to handle heavy-duty jobs. Start with a corded drill, and save the purchase of a cordless model for later.
It's worth investing in good-quality tools that feel comfortable in your hand. They'll last years, maybe even a lifetime.
Find the main water shutoff
When a water pipe leaks, you need to stop it right away. Otherwise the water can do extensive damage to your home and your bank account.
Shutoff valves for individual pipes are typically found along supply lines and near fixtures, but those valves can break. So it's important to know how to stop the water supply to the whole house.
The main shutoff valve might be right next to an outdoor meter or inside the house. Some water meters have two shutoff valves, one on each side. If yours does, use the valve farthest from the street.
It's a good idea to close and open the main shutoff valve once a year to prevent it from corroding.
Reset the electrical power
When the power goes out in part of your house, it means a circuit breaker has tripped or a fuse has blown, shutting off power to an electrical circuit. Usually the cause is an overload, meaning too many electrical devices are trying to draw power from one circuit.
Most homes have electrical panels with circuit breakers, switches that flip when there's a problem with the circuit. Resetting it isn't rocket science, but there's a little trick to it: You have to turn the switch all the way off first before you can turn it back on.
It's a good idea to turn off or unplug all the lights, appliances and other devices on the circuit before you reset the circuit breaker. When the power is back on, leave some things shut off, or plug them into a receptacle on a different circuit.
Sometimes a circuit shuts off because a ground fault interrupter has tripped on a receptacle. You can fix that by pushing the reset button on the receptacle. (GFI receptacles are usually found near water, such as in bathrooms and kitchens.)
If your house has older-style fuses, you fix a blown circuit by unscrewing the bad fuse in the electrical panel and screwing in a new one. However, it's important to use a fuse with the right wire gauge to handle the circuit's amperage. You can foolproof that process preventively by screwing a Fustat fuse adapter into each fuse socket on your electrical panel. It will change the socket size, so you can't screw in a fuse that's the wrong size.
If the breaker continues to trip or the fuse keeps blowing even though you've reduced the electrical load, you have a bigger problem and a potential safety hazard. Call an electrician.
Restart a garbage disposal
When disposal blades jam, a little force is required to dislodge them.
Most units have a hole on the underside of the disposal that an Allen wrench fits into. Check underneath the unit to see if the wrench is attached. If not, you can buy a set of Allen wrenches fairly cheaply.
Unplug the disposal, or turn off the power at the electrical panel. Be certain you have done so. Then insert the wrench into the hole and work it back and forth until the blades are freed.
Remove debris from the disposal. (You did turn the power off, right?) Press the reset button, usually on the bottom of the unit near the point where the electrical cord enters the disposal, and then turn the power back on.
Open garage doors when the power is out
This one's easy. There should be a cord — probably red — hanging overhead from part of your garage door opener. When you pull the cord, it disengages the opener. You can then open the garage door by hand.
If the door is open when the opener fails, however, don't try pulling the cord. If could cause the door to come crashing down.
Unclog a toilet
Everybody hates this chore, but sometimes you just have to take the plunge — or more accurately, take up the plunger.
Use a flange plunger, which has a cone extending from the bottom of the bell. It creates a better seal in a toilet than a cup plunger, so you can create the suction you need to clear the clog.
Put on rubber gloves, and if necessary, bail out the toilet bowl until it's only half-full. (Yeah, we know. It's gross.) Then position the plunger over the drain hole, and pump up and down a few times to let the air out and create a vacuum seal.
Once you feel the resistance that indicates you have a good seal, pump in rapid, short strokes four or five times without breaking the seal, and then pull out the plunger. If you're lucky, the clog will clear. If you're not, repeat.
For really tough clogs, you may need to use a toilet auger. It has a rubberized guard, so it won't scratch the porcelain the way a regular plumber's snake might.
By the way, you can use a similar technique to unclog a sink, but use a cup plunger. In addition, use a wet rag to plug the overflow drain or the second drain in a double kitchen sink.
Put out a grease fire
The best way to deal with a grease fire is to use an ABC extinguisher, a multipurpose extinguisher that can be used on fires caused by grease, electricity or ordinary combustibles such as paper, plastic and wood. It's a good idea to buy one and keep it in an easily accessible place in your kitchen.
If you don't have one, smother the flames with a lid that covers the pan completely. That will cut off the oxygen that feeds the fire.
Turn off the burner if you can do so safely, and don't touch the pan until it has cooled.
Some people recommend pouring on baking soda to smother a grease fire, but you should use that method only if it's your only recourse. It takes longer for baking soda to stop a fire, and it requires you to come into close contact with the flames.
If a fire gets beyond your control, get everyone out of the house immediately and call 911 once you're outside.
No matter how small the fire, you should always call the fire department, even if you've managed to put out the flames.
Change your filters
Changing the filter in your air conditioner doesn't qualify as an emergency, but it could prevent one.
A dirty filter slows air flow, wastes energy by making your heating and cooling system work harder and lets dirt into the system, which wears out parts and could hasten a breakdown. If Murphy's Law holds true, that breakdown will happen during a particularly grueling heat wave — and that's an emergency.
Change filters throughout the summer and winter for your central air conditioner. The same filter works for both the heating and cooling systems.
Check it monthly and replace it when it looks dirty — or clean it, if it's a reusable filter. You should change or clean the filter at least every three months.
Sources: We compiled our list with help from Chuck Kester of DC Home Inspection Services, Chris Havlik of BEI Maintenance & Repair, and Kenneth S. Parker of H.L. Parker Electric, all of Akron, Ohio; Inspector Sierjie Lash of the Akron Fire Department; www.energystar.gov; and the books "Tools" by Steve Dodds and "What's a Homeowner to Do?" by Stephen Fanuka and Edward Lewine.